About ASAA/NESA Classes

Level I Course

The ASAA / NESA Level I course begins with several general topics including: overview of the industry, ethics, building construction, safety, law, codes and standards, general electricity, microprocessors and tools. It prepares technicians for system installations and service repairs by covering the basic steps used in our industry including: documentation, site survey, component location, cabling and testing.

The course is two days of instruction and a half a day for review and testing.
This course satisfies the requirements for Alarm Agents (sales) and Technicians.

Electronics

The ASAA / NESA Electronics course covers parts of a circuit, types of circuits, measuring electricity, applying Ohm’s law, conversions, load calculations and voltage drop. It is an in depth course on trouble shooting and using a meter.

This course is one day of instruction and a half day for review and testing.

This course satisfies one of the requirements for Managers. It is also a great course for all technicians, but is NOT required for them.

Fire Installation and Wiring Codes

The ASAA / NESA Fire Installation and Wiring Codes course focuses on NFPA 72 and covers: Fundamentals, Fire Signatures, Effects and States, Codes & Standards, AHJ, Fire Alarm Equipment Overview, Initiating Devices, Signal Transmission, Controls, Power, Notification Appliances, Signaling Systems, Ancillary Circuits and Documentation.

Fire Installation and Wiring Codes is based on: NFPA 72 (’10) and NFPA 70 (’11). Students are encouraged, but not required, to bring these books with them for discussion.

This course is two days of instruction and a half day for review and testing.

This course satisfies one of the requirements for Managers. It is also a great course for all technicians that deal with fire alarm systems, but is NOT required for them.

Combined for Convenience

The Arkansas Security Alarm Association teaches the Electronics (occasionally referred to as “Level 2A) and Fire Installation and Wiring Codes (occasionally referred to as “Level 2B” ) courses consecutively. We do this to make it more convenient for both the student and the instructor. These courses are still two separate courses. If you take both courses, you will need to pay for both courses. It is possible to pass one and fail the other. You will then only need to re-take the failed course.

Daily Schedule

Classes begin at 8:00 a.m. sharp!

The below times are approximate and will vary based on class size, general knowledge of the students, and the flow of the class.

Level I usually lasts until 4:30-5:00 p.m. the first two days of class (Tuesday and Wednesday for classes held in Little Rock, Friday and Saturday for classes held in Bentonville and Fort Smith). The 2-hour test usually begins about 9:00 a.m. on the third day.

Fire Installation and Wiring Codes usually begins at 8:00 a.m. The first two days of the fire class (Tuesday and Wednesday for Little Rock, Thursday and Friday for Bentonville and Fort Smith) usually run until 5:00 – 5:30. The third day of class is for review and testing. The goal is to complete the course by noon of the third day. Electronics will begin immediately following the Fire Installation and Wiring Codes exam.

Electronics begins immediately following the Fire Installation and Wiring Codes exam and usually lasts until 4:30-5:00 p.m. but may go later, as it is a day and a half class. There is practical homework that is reviewed the second day of the class. Following the review of the homework on the second day (the fourth day if taking both the fire and electronics courses), there is a one-hour exam. It usually begins about 8:30-9:00 a.m. but may start later.